Supported Hardware

Ubiqua Protocol Analyzer supports different hardware adapters as specified in the table below. All the supported hardware drivers are located in Program Files\Ubilogix\Drivers folder in the drive where you installed the software. As provided from the vendor each adapter is already programmed with the appropriate firmware application. If you need more information about the firmware application or the adapter’s drivers please refer to the Ubilogix support webpage.

Name	Parts Number	2.4GHz	SubGhz	Drivers
JN5169 USB Dongle	OM15020	✔		`\Drivers\FTDI`
JN5179 USB Dongle	OM15021	✔		`\Drivers\FTDI`
KW2x: Kinetis KW2x Family	TWR-KW24D512 and KW24D512-USB	✔		`\Drivers\FS KW2x`
Kinetis® KW41Z-2.4 GHz	KW41Z	✔		N/A
CC2531 Ev. Module Kit	CC2531EMK	✔		`\Drivers\TI`
TI CC135xR	LAUNCHXL-CC1352R1	✔	✔	`\Drivers\TI`
TI CC26x2	LAUNCHXL-CC26X2R1	✔		`\Drivers\TI`
Open Sniffer	Open Sniffer for 802.15.4	✔	✔	N/A
Zigbee USB Stick	Zigbee USB Stick U1	✔		Provided by the vendor

Legacy Supported Hardware

Name	Parts Number	Drivers
MC1322x USB	1322X-USB	`\Drivers\FTDI`
JN5168 USB Dongle	DR1198	`\Drivers\FTDI`
ZigBit USB Stick	ATZB-X-23x-USB	`\Drivers\MICROCHIP`
RZ600 Evaluation Kit	AT86RF212 (SubG) and the AT86RF23x families	`\Drivers\MICROCHIP`
TOUCAN Wireless Sniffer	RFA-Z106-SN TOUCAN	`\Drivers\FTDI`

Ubiqua Sniffer

You can create your own adapter firmware and communicate with Ubiqua, with any hardware of your choice, using the Ubiqua Sniffer API. This communication protocol describes the messages that your sniffer must support in order to transfer the over-the-air data to Ubiqua using a UART interface.

In this guide you can find an Ubiqua Sniffer API implementation for the Texas Instruments CC2531 and a step by step guide explaining how to use it to sniff an IEEE 802.15.4 network.